Grass Valley Profile Family Audio Signal Processing Board - Manual (Page 54)

ASPB Installation
54 ASPB Installation
3. To connect ASPB2 Sharcnet cables to the third Serial Digital I/O board:
a. Locate the ASPB2 board. ASPB2 is the ASPB installed in the higher
numbered board slot.
b. Connect a Sharcnet ribbon cable between the ASPB2 Sharcnet Out1
connector and the Sharcnet In connector of the Serial Digital I/O board in
the next higher numbered board slot (
Ê in example Figure 17).
c. Connect a Sharcnet ribbon cable between the ASPB2 Sharcnet In1
connector and the Sharcnet Out connector of the Serial Digital I/O board
in the next higher numbered board slot (
Ë in example Figure 17).
d. If there are more Serial Digital I/O boards continue with step 4 below,
otherwise proceed with “Connecting Sharcnet Cables Between Two
ASPBs” on page 57.
4. To connect ASPB2 Sharcnet cables to the fourth Serial Digital I/O board:
a. Connect a Sharcnet ribbon cable between the ASPB2 Sharcnet Out2
connector and the Sharcnet In connector of the Serial Digital I/O board in
the next higher numbered board slot (
Ì in example Figure 17).
b. Connect a Sharcnet ribbon cable between the ASPB2 Sharcnet In2
connector and the Sharcnet Out connector of the Serial Digital I/O board
in the next higher numbered board slot (
Í in example Figure 17).
c. Now that the ASPB2 Sharcnet cables have been connected to the Serial
Digital I/O boards go to “Connecting Sharcnet Cables Between Two
ASPBs” on page 57.