Grass Valley Profile Family Audio Signal Processing Board - Manual (Page 19)

Gaining Access To the Profile Chassis Covers
ASPB Installation 19
Gaining Access To the Profile Chassis Covers
You can install the ASPB with the Profile chassis fully extended on the rack slides
if the instrument rack is adequately anchored to prevent tipping, and if there is
sufficient slack in the cables connected to the rear panel to allow the chassis to
fully extend on the slides.
To gain access to the chassis covers:
1. Turn Profile system power off and remove the power cord.
2. Loosen the front panel retaining screw and pull the chassis out until the slide
sections latch. If the rack is not anchored firmly, remove the chassis from the
rack. (For more information, see the discussion on rack mounting in the
product Installation Manual.)
WARNING: To avoid possible injury, get help when removing the Profile
chassis from the rack. The Profile chassis is too heavy for one person to
remove from an equipment rack.
!