Removing the chassis covers – Grass Valley Profile Family Audio Signal Processing Board User Manual

Page 20

Text mode
Original mode

ASPB Installation

Removing the Chassis Covers

To remove both chassis covers:

NOTE: The front chassis cover must be removed first because it overlaps the
rear chassis cover (

in Figure 1).

1. Confirm that the Profile system power is switched off and the power cord is

removed.

2. Use the Torx tool with the T10 tip to remove the top screws from the front

chassis cover (

Ê in Figure 1) and then use the T15 tip to remove the

pan-headed side screws.

NOTE: Take care not to lose these chassis screws. They are required to meet
the EMI specifications for the Profile system. Also, not all the screws shown
in Figure 1, are present on a PDR100.

3. Use the Torx tool with the T10 tip to remove the rear chassis cover

(

Ë in Figure 1) which covers the circuit boards.