Grass Valley Profile Family Audio Signal Processing Board - Manual (Page 60)

ASPB Installation
60 ASPB Installation
Reassembling the Profile Chassis
To reassemble the Profile chassis:
1. Apply stick-on labels on the Profile chassis rear panel to help identify all new
board locations. (See Figure 20.)
2. Bundle any loose cables with the tie wraps provided.
3. Use the Torx tool with the T10 tip to reinstall the rear board hold-down
bracket. (See Figure 2 on page 23.) Make sure that boards in the chassis fit
into the grooves in the bracket.
CAUTION: To prevent damage to an Analog Composite Monitor board, do
not install a short board extension on the front hold-down bracket at the
Monitor board location.
4. If necessary, move or remove any short board extensions on the front board
hold-down bracket. Then use the Torx tool with the T10 tip to reinstall the
bracket. (See Figure 2 on page 23.)
5. Use the Torx tool with the T10 tip to reinstall the rear chassis cover with the
screws previously removed.
NOTE: When reinstalling rear and front chassis covers, start all the screws
before tightening them.
6. Use the Torx tool with the T10 and T15 tips to reinstall the front chassis
cover with the screws previously removed. (See Figure 1 on page 21.)
7. Reinstall the Profile chassis in the rack and reconnect all external cables
previously removed.
8. Connect ASPB audio interface chassis if required. For assistance on
connecting audio interface chassis refer to “Installing Audio Interfaces” on
page 65.
!!