Grass Valley NewsBrowse Desktop Browsing System Installation v.2.0 - Manual (Page 82)

82 NewsBrowse Installation and Configuration Guide 25 May 2004
Chapter 3 Configuring the NewsBrowse System
You can define six ISS rules, two for each asset-type. To ensure consistency, for each
asset-type you require, add both rules.
The following table maps the six ISS rules and provides an example text string for
each rule, as appears in the Existing Rules box when the rule is added.
Refer to “Configure Rules Automation: Sequential encoder” on page 90 for
sequential encoder rules.
Test: ISS + Server stage
The following test exercises system functionality exclusive to the basic
configurations for the ISS + Server stage. A successful test verifies that the basic
configurations are correct.
Test description: Trigger rules by creating a clip on a Profile Media server while the
Rules Wizard service is off, then on.
Run the test as follows:
1. Make sure that the NewsBrowse system is not in use.
NOTE: Running these tests will tie up a channel and could collide with commands
from the Ingest Schedule page. Inform operators that they must not use the
channels under test.
2. Stop the Thomson Rules Wizard service on the NewsBrowse server.
3. Start the Thomson Resolver service and the Thomson Metadata service on the
NewsBrowse server.
4. From the NewsBrowse server, open the NewsBrowse application.
5. Ingest a short test clip. On the related tab, verify that only the MPEG proxy asset
is created. This could take a few minutes after the ingest recording completes.
6. Start the Thomson Rules Wizard service on the NewsBrowse server. In the
NewsBrowse application on the related tab, verify that the thumbnail, storyboard,
or Real Video assets are created for the MPEG asset, as per your currently
configured rules. This could take a few minutes.
7. Ingest a short test clip. On the related tab, verify that the MPEG proxy asset is
created and the other assets are created as well. This could take a few minutes.
If Proxy MPEG… Create Thumbnail assets Create Storyboard assets Create Real Video assets
… exists when
Rules Wizard
Starts up CreateIfSourceExist
Source:DEFAULTDOMAIN/
PROXY1/*/*,video/proxy.mpeg
Destination:DEFAULTDOMAIN/
PROXY1/*/*,stillImage/
proxy.thumbnail Priority:Normal CreateIfSourceExist
Source:DEFAULTDOMAIN/
PROXY1/*/*,video/proxy.mpeg
Destination:DEFAULTDOMAIN/
PROXY1/*/*,stillImage/
proxy.storyboard Priority:Normal CreateIfSourceExist
Source:DEFAULTDOMAIN/
PROXY1/*/*,video/proxy.mpeg
Destination:DEFAULTDOMAIN/
PROXY1/*/*,video/proxy.rm
Priority:Normal
…is created CreateIfSourceIsCreatedClosed
Source:DEFAULTDOMAIN/
PROXY1/*/*,video/proxy.mpeg
Destination:DEFAULTDOMAIN/
PROXY1/*/*,stillImage/
proxy.thumbnail Priority:Normal CreateIfSourceIsCreatedClosed
Source:DEFAULTDOMAIN/
PROXY1/*/*,video/proxy.mpeg
Destination:DEFAULTDOMAIN/
PROXY1/*/*,stillImage/
proxy.storyboard Priority:Normal CreateIfSourceIsCreatedClosed
Source:DEFAULTDOMAIN/
PROXY1/*/*,video/proxy.mpeg
Destination:DEFAULTDOMAIN/
PROXY1/*/*,video/proxy.rm
Priority:Normal