Grass Valley NewsBrowse Desktop Browsing System Installation v.2.0 - Manual (Page 50)

50 NewsBrowse Installation and Configuration Guide 25 May 2004
Chapter 3 Configuring the NewsBrowse System
Configure ASK Location: Single-channel encoder
This page tells the single-channel encoder where to look for the ASK service, which
is one of the Media Frame Core software components and runs on the NewsBrowse
server. The function of the ASK is to store the location of other services in the
NewsBrowse system that the encoder might need to access.
Configure Ingest Control: Single-channel encoder
This page provides general information about the single-channel encoder and how it
controls the Profile Media Server and (if you use one) a backup VTR.
Ba
s
ic
A
d
va
nc
ed
Do
n
o
t mo
d
ify
http:// root_nb_enc_n:280 ASK Location
! Enter the name of the NewsBrowse server
! Port 9010 is required. See “Ports and services convention” on page 33 .
! Saves changes. Changes are lost if you leave the configuration page without
updating.
Always click Update… buttons after making changes
It is not necessary to restart a service to put these settings into effect.
Ba
s
ic
A
d
va
nc
ed
Do
n
o
t
m
o
d
ify
http://localhost:280 Single Channel Encoder Ingest Control Access this page from the local single-channel encoder.
! Select the protocol that controls the Profile.
! For Ethernet, enter IP Port 9330 . For Serial Port, select a COM Port. See
“Ports and services convention” on page 33 .
! 360 minutes recommended
! If using a backup VTR, select Enable
! If using a backup VTR, select a COM port.
! Adjust as required by the backup VTR a
a. Tune at a later time to make sure the VTR start matches the Profile
and encoder start time.
! ! Saves changes. Changes are lost if you leave the configuration page without
updating.
Always click Update… buttons after making changes
Start or restart the Thomson Ingest Control service on the single-channel
encoder.