Grass Valley Jupiter v.1.0.0 - Manual (Page 62)

54 Jupiter AccuSwitch Soft Panels and Status Display Instruction Manual
Section 5 — VSD Installation
.
Installing VSD Using the VSD Installer
The following instructions show the steps needed to install the Visual
Status Display (VSD) application. The PC, which the VSD application is
installed on, must have network settings that allow communication with
the Jupiter or Prelude network. Consult with your Network administrator
for this information.
To begin installing the VSD:
1. Insert the supplied software CDROM into the computer’s CD Drive
and follow the prompts.
Note The CD should automatically start the installation process. If not, browse to
the CD, using Window Explorer, and then click the setup.exe icon.
• If Microsoft .NET Framework was not installed earlier, you may see a
message asking if you want to install Microsoft .NET Framework. If so,
select “Yes.” The 3.5 version of .NET is located on the CD. Depending
on the OS version, the system may reboot automatically during this
process.
Note After an auto reboot, it may take several minutes for the system to display the
VSD installation welcome screen.
The Jupiter VSD Welcome screen will then appear ( Figure 63 ).
Table 9. System Requirements for Installing .NET Framework 3.0
Processor Minimum 400 megahertz (MHz) Pentium processor
Recommended: 1 gigahertz (GHz) Pentium processor
RAM: Minimum: 96 megabytes (MB)
Recommended: 256 MB
Hard Disk Up to 500 MB of available space may be required.
Installation Drive The .NET Framework 3.5 default installation location is the PC’s system drive (the
drive that boots your system). Ensure at least 500 MB is available on the system drive.