Grass Valley CopperHead Pro - Manual (Page 71)

65
Base Station Connectors
Base Station Connectors
Reference Numbers refer to the overview diagrams in Base Station: 12Volt DC (single/dual)
on page 80.
AC Power Input Connector- Models CHG3-BS-Pro-95VD-xxx-xxx
12VDC Input Power Connectors - Models CHG3-BS-Pro-2ST/2MX/NEU
Base Station #20
IEC C14 receptacle
Panel Mounted IEC C14 AC Power Receptacle: 110/220 VAC
Fuses:
• Two 3.15 amp slo-blo fuses (5 x 20mm)
Base Station #11
XLR4 Male
(Ext View)
Base Station 12VDC power connector pinouts:
• Pin 1: GND
• Pin 2: Unused
• Pin 3: Unused
• Pin 4: +12 VDC In
Connects to ADAP-AC-04 or a customer-supplied 12VDC power
supply.
This connector is wired in parallel with terminal block #12.
Base Station #12
Terminal block
(Ext View)
Base Station Terminal Block pinout test:
• Pin 1: GND
• Pin 2: +12VDC In
Note: This connector is wired in parallel with XLR4 Male #11.