Grass Valley CopperHead Pro - Manual (Page 34)

28
CopperHead System Components
MPS External PowerWafer Power Supply
MPS External PowerWafer Power Supply
The CopperHead MPS external power supply provides 95 watts of 12VDC power and fiber
connectivity from Base Station to Camera Unit equipped with a CopperHead PowerWafer.
Connectivity between the MPS unit to the camera can be configured using either a Hybrid
OpticalCON connector or a SMPTE 304M connector. The nominal distance between them is
240 meters (780 feet).
Connectivity between the MPS unit and Base Station uses "dry" fiber and can be configured
with a "dry" OpticalCON connector or two ST connectors. The MPS is powered locally with
standard AC power. The unit is free-standing (see
Hybrid Fiber Cable between MPS Power
Unit and Camera Unit on page 46 for system configuration with the MPS Power Supply and
PowerWafer).
Fig. 3-18: MPS Power Supply, Front and Rear
• 1: AC Power Receptacle: 100-240V 50/60 Hz
• 2: Fuse compartment: see AC Power Input Connector- Models CHG3-BS-Pro-95VD-xxx-
xxx on page 65 for the fuse specification.
• 3: Power Switch
• 4: For Future Use (RJ45)
• 5: "Dry" Fiber Optic Connection to CopperHead Base Station: this removable plate
can be equipped with two ST connectors or a "dry" OpticalCON connector (see
Figure 3-19 ).
• 6: Heat Sink
• 7: Powered Fiber Optic Connection to CopperHead Camera Unit: this removable
plate can be equipped with a SMPTE 304M connector or a powered OpticalCON
connector. See
Figure 3-20 .