Grass Valley CopperHead Pro User Manual
Page 54
48
Camera Unit and Power Supply Installation
SMPTE Hybrid Fiber between HDX Power Supply and Camera Unit
SMPTE Hybrid Fiber between HDX Power Supply and Camera Unit
ST Fiber Connectors between Base Station and HDX Power Unit, camera powered by
Copperhead PowerPlus.
Fig. 4-14: SMPTE Hybrid Fiber between the HDX Power Supply and Camera Unit
Mount the PowerPlus J to the CopperHead Camera Unit K as shown in
CopperHead Pro Camera Unit with the PowerPlus
on page 38, being sure to plug the
PowerPlus' tactical fiber "dongle" X into the swivel-mounted fiber connector on Camera
Unit X.
Connect dry (unpowered) fiber cable A between the fiber connector(s) C on Base Station B
and the "dry" fiber connector(s) D on the HDX Power Supply E. Connect the HDX Power
Supply E to AC Mains F. Connect a length of hybrid fiber cable G between the HDX Power
Supply E and the swivel-mounted SMPTE 304M connector X on the PowerPlus J. The hybrid
fiber cable can be equipped with either OpticalCON or SMPTE 304M connectors I. The
camera and Camera Unit will be powered via the hybrid cable by the PowerPlus J.
Note:
Connectors at each end of the fiber cable must be SMPTE 304M I.
OpticalCON connectors cannot be used in this configuration.