Grass Valley CopperHead Pro - Manual (Page 48)

42
Camera Unit and Power Supply Installation
Connecting Base Station to Studio Infrastructure
Connecting Base Station to Studio Infrastructure
Connecting the CopperHead Base Station requires the following:
• Two BNC-terminated coax cables to connect to your infrastructure
• CHBR-Pro cable
• Camera Remote Panel
• XLR cable to connect to your intercom system (see Intercom connectivity on page 43)
• Access to your video switcher's tally outputs (optional)
• Fiber cable to Camera Unit
Fig. 4-8: CopperHead Pro Base Unit Connections
• 11: 12 VDC Input: connects to 12VDC power supply
• 20: 120/220 VAC Input: connects to AC mains
• 14: Fiber: connect fiber cable to CopperHead Camera Unit
• 15: Remote/Tally: connects to CHBS-PRO cable. This breakout cable connects to a
Camera Remote Control Panel. The pigtail connects to the tally output of a switcher or
to a studio Tally system. See
CHBR-PRO Base Station Remote Cable on page 74 for
details.
• 16: Intercom: connects to the house intercom system is connected here (see Intercom
connectivity on page 43)
• 17: SDI Out: connects to the digital video output (HD/SDI-SDI) from your camera is
found here
• 18: Return Video In: connects to the house genlock/sync or return VBS analog video
• 19: Return Video Mode Switch: switches to optimize the return video path (18) for
Genlock/Sync or analog return VBS video