Grass Valley CopperHead Pro - Manual (Page 30)

24
CopperHead System Components
Base Station Rear Panel
Base Station Rear Panel
Fig. 3-13: CopperHead Pro Base Station Back Panel (Dual model shown)
• A: Power Connector (see Rear Panel Section A - Power Connector on page 24)
• B: Fiber Connectors (see Rear Panel Section B - Optical Connector on page 25 )
• C: Signal Connectors (see Rear Panel Section C - Signal Connectors on page 26)
Rear Panel Section A - Power Connector
The CopperHead Base Station can be configured for DC or AC power.
12VDC Power Interface
This power interface is used on CopperHead Base Stations that are not equipped with
internal power supplies. This type of Base Station is typically used with Camera Units
powered locally with a battery or a local power supply at the camera.
Fig. 3-14: 12VDC Power Connector
• 11: 12V DC Power input connector (XLR 4 Pin)
• 12: 12V DC Input - terminal block: can be used in lieu of the 4-pin XLR or in parallel as a
redundant input. See Base Station Connectors on page 65 for pin-out details.
• 13: For Future Use (RJ45)