Grass Valley CopperHead Pro User Manual
Page 42
36
Camera Unit and Power Supply Installation
Mounting the Copperhead Camera Unit with the PowerWafer
Mounting the Copperhead Camera Unit with the PowerWafer
When mounting the CopperHead Camera Unit, always position the camera so that the
battery mounting plate at the rear of the camera is easy to access. Ensure that the camera is
well-supported and stable. If a battery is mounted remove it and put it to one side.
Installing the CopperHead Camera Unit typically involves one of the following three
configurations.
• CopperHead Pro Camera Unit with a battery (see
• CopperHead Pro Camera Unit with the PowerWafer (see
Camera Unit with the PowerWafer
• CopperHead Pro Camera Unit with the PowerPlus (see
Camera Unit with the PowerPlus
Mounting the CopperHead Pro Camera Unit with a battery
When the camera is powered locally at the camera position, either by a battery (as shown)
or by a local power source, tactical fiber is typically the preferred connection to Base
Station.
Fig. 4-1: Mounting the CopperHead Pro Camera Unit to the Camera
1 Attach the CopperHead Pro Camera Unit A to the camera battery mounting plate B. The
mounting is mechanically identical to attaching a battery.
2 Mount the battery C to the CopperHead Pro Camera Unit battery mounting plate D
exactly as you would mount the battery to the camera.
3 Instructions for attaching the required cables between the camera and Camera Unit
can be found in