Grass Valley Aurora Edit LD v.6.5 Installation - Manual (Page 76)

62
Aurora Edit Installation Guide November 25, 2008
Chapter 1 Aurora Edit Security
Configuring SNFS for SAN Security
The StorNext File System (SNFS) runs on the File System Manager(s) as part of the
SAN network. In order to use security on Aurora Edit workstations, you need to modify
the SNFS configuration to use Windows Security and then power cycle the FSMs.
NOTE: You cannot use the SNFS Configuration Tool to add Windows Security to
SNFS. Using the Configuration Tool changes other settings you don’t want to modify.
To add windows security to SNFS:
1. On the primary FSM, go to
C:\MediaAreaNetwork\config
.
2. Using Notepad, open the file
default.cfg
.
3. Change the
Windows Security
line’s value to
YES
.
If the line item doesn’t exist, add it to the file.
4. Save the file and exit Notepad.
5. Repeat these steps 1 through 4 on the backup FSM.
6. Power cycle the FSMs as follows:
a. Shut down the backup FSM.
b. Reboot the primary FSM.
c. Power on the backup FSM.