Grass Valley Aurora Edit LD v.6.5 Installation - Manual (Page 61)

November 25, 2008 Aurora Edit Installation Guide
47
Verifying the DCOM Configuration
removed from the video server (not the Aurora Edit workstation).
f. Click
OK
to close Server Settings.
g. Select the
Total Maximum Transfers
from the drop-down list.
The Total Maximum Transfers is the total number of streams for this particular
instance of the SmartBins Service. Select
4
if the SmartBins Service is installed on
a DSM, or select
6
if the SmartBins Service is installed on a standalone PC.
NOTE: Increasing the number of Total Maximum Transfers affects the
bandwidth on the NAS system.
h. Enter the name of the License Server; this is the same as the License Server in
Aurora Edit (see “Configuring General Options” on page 32 ).
i. Enter the name of the MediaFrame Server.
j. Enter the K2 MDI Name.
k. Click
OK
to close the setup tool.
The SmartBins Service restarts.
Verifying the DCOM Configuration
Transfer SmartBins require that DCOM permissions are configured correctly on the
media server.
To verify the DCOM configuration:
1. Click
Start
on the Windows taskbar and choose
Run
.
2. Enter
Dcomcnfg.exe
and click
OK.
3. Expand the
Component Services
branch, and the
Computers
branch beneath it.
4. Right-click on
My Computer
and choose
Properties
.
5. Click the
COM Security
tab.
6. In the
Access Permissions
section, click
Edit Limits
.
7. Select
ANONYMOUS LOGON
and verify that the
Remote Access
box is allowed
(checked).
8. Select
Everyone
and verify that the
Remote Access
box is allowed (checked).
9. Click
OK
and then
OK
again to close the Properties window.
10. If you made any changes, you must reboot your system; if no changes were required
you can exit Component Services.