Grass Valley Aurora Edit LD v.6.5 Installation - Manual (Page 25)

November 25, 2008 Aurora Edit Installation Guide
11
Configuring IP Addresses (NAS Only)
Configuring IP Addresses (NAS Only)
Before using a NAS system, you need to configure the NAS server IP addresses for the
NAS servers.
To set the IP address for the NAS Servers:
1. From any PC on your network with Internet access, right-click on Network Places and
select
Properties
.
2. In the Network & Dial-up Connections window, select the Local Area Connection for
your primary public ethernet port, right-click, and select
Properties
.
3. In the Properties window, select
Internet Protocol (TCP/IP)
and click
Properties
.
The Internet Protocol (TCP/IP) Properties window opens:
4. Click
Use the following IP address:
and set the IP address and Subnet mask to the
Thomson Grass Valley settings, using an unassigned address on the same subnet.
5. Click
OK
twice.
6. Using Internet Explorer, log on to the NewsShare NAS application.
The default address is 192.168.50.20:9890.
7. Configure your network ports according to the type of NAS system you have:
• For the NewsShare NAS Fibre Channel Network system, select
Network | Network Port Configuration
.
• For the NewsShare NAS Serial ATA Network system, select
Network | Network Ports
.
8. Configure the Public IP, Private IP, and Netmask addresses for both Nodes.
NOTE: Private IP is supported on NAS Fibre Channel Network systems only.
An example of an appropriate scheme is:
9. Click
Save
.
10. Reboot your computer.
11. Follow steps 1-5 and reset the IP address for your computer back to its original
settings.
Name Node1 Node2
Public IP 192.168.50.20 192.168.50.21
Private IP 192.168.50.22 192.168.50.23
Netmask 255.255.0.0