Grass Valley Aurora Edit LD v.6.5 Installation - Manual (Page 64)

50
Aurora Edit Installation Guide November 25, 2008
Chapter 6 Installing the Conform Server
System Requirements
Hardware Requirements
See the Release Notes on the installation CD for current system requirements.
Software Requirements
The following software components are required to run the Conform Server:
• Microsoft Windows 2003 Server with Service Pack 2
• Microsoft IIS 6.0 (IIS must be installed before .NET)
• Microsoft .NET Framework 3.5 SP1
Installation Procedure
1. Uninstall any previous versions of the SNFS Client, GVG_MLib, Generic iSCSI, or
Conform Server software via the Windows
Add or Remove Programs
control panel.
2. Install the SNFS Client software.
a. On the Aurora Suite CD, go to
Software Installs\SNFS
and double-click on
SnfsSetup32.exe
.
b. Follow the instructions in the table below for each installation screen.
3. If you are using a Fibre Channel card, verify that the IP MTU uses the same setting as
other Aurora Edit clients.
4. Install the GVG_MLib software.
a. On the Aurora Suite CD, go to
Software Installs\K2 3.2.74.967\GVG_Mlib
and
double-click on
setup.exe
.
b. Follow the instructions in the table below for each installation screen.
On this screen... Do this...
Welcome Click
Next
.
Ready to Install Click Next to begin the installation.
Aurora Suite Successfully Installed Click
Finish
.
On this screen... Do this...
Welcome Click Next .
Server Names Enter the name of the primary FSM server (and the secondary
FSM Server, if any) and click
Next .