Grass Valley Aurora Edit LD v.6.5 Installation - Manual (Page 26)

12
Aurora Edit Installation Guide November 25, 2008
Chapter 2 Introducing NewsShare
Configuring Aurora Edit Workstations
For each Aurora Edit workstation on your NAS network, you must mount the NAS:
You must mount the NAS volume from each Aurora Edit workstation before installing
the Aurora Edit software as described in Chapter 3.
Configuring Workstations for NAS
For each client machine and the Conform Server running the SmartBin Service, if
applicable, you need to mount the NAS volume before installing the Aurora Suite
software. In addition, if the client machines are used by more than one user login, you
need to log in under each user account and mount the NAS volume.
To mount a NAS volume:
1. On the machine you want to map the drive to, open
My Computer
and select
Tools |
Map Network Drive
.
2. Select the NAS drive.
3. Type in the name of the NAS folder where the shared database resides.
4. Check the
Reconnect at login
checkbox.
5. Click
Finish
.
Configuring Workstations for K2
1. Uninstall any previous versions of the SNFS Client, GVG_MLib, Generic iSCSI, or
Conform Server software via the Windows
Add or Remove Programs
control panel.
2. Install the SNFS Client software.
a. On the Aurora Suite CD, go to
Software Installs\SNFS
and double-click on
SnfsSetup32.exe
.
b. Follow the instructions in the table below for each installation screen.
3. Following the instructions in the K2 Storage System Instruction Manual, do the
following, if not set up already:
• Set up the Control Point PC.
• Run the K2 Config application to set up the K2 Server and Gigabit Ethernet switch.
• Connect the Aurora Edit workstation to the K2 Server via the Gigabit Ethernet
switch.
On this screen... Do this...
Welcome Click Next .
Ready to Install Click
Next
to begin the installation.
Aurora Suite Successfully Installed Click
Finish
.