H3C Technologies H3C Intelligent Management Center User Manual
Page 88
80
Feature
Description
Software queuing
Queue Type—Select a software queuing type. Options are Not Set, FIFO,
CQ, PQ, WFQ, and RTPQ. Different queuing types have different
configuration parameters.
FIFO:
•
Queue Length—Specify the number of packets allowed in the FIFO
queue, in the range of 1 to 4096.
CQ:
•
List Number—Select a CQ list number. For information about
configuring CQ lists, see "
PQ:
•
List Number—Select a PQ list number. For information about
configuring PQ lists, see "
."
WFQ:
•
Match Priority—Select a priority type for WFQ scheduling to base on.
Options are dscp and ip-precedence.
•
Queue Length—Specify the number of packets allowed in each WFQ
queue, in the range of 1 to 1024.
•
Total Queue Count—Specify the total number of WFQ queues. This
value must be a power of 2. The value range for the power is 4 to 12.
RTPQ:
•
Start Port—Specify the start port number of a port range. The device
assigns packets with a destination port number in the port range to the
RTP queue.
•
Start Port—Specify the end port number of the port range.
•
Bandwidth—Specify the maximum bandwidth allowed for the RTP
queue.
•
CBS—Specify the committed burst size in bytes allowed for the RTP
queue.
5.
Click Next to move to the Basic Information page.
6.
Configure the following attributes of the deployment task:
{
Task Name—Enter a name for the deployment task.
{
For Deployed Configuration—Specify how the configurations already deployed to the interface
are treated.
−
Overwrite—Undeploys configurations applied to the interface and then deploys the
configurations in the deployment task.
−
Ignore—Uses the configuration on the interface if the same type of configuration exists on
the interface. The corresponding configuration in the deployment task is ignored.
{
Predefined Execution Time—Specify the time when the deployment task will be executed.
Options are Immediately and Schedule. If you select Schedule, the deployment task is
scheduled to run at the time you set. The time you set can be accurate to the second.
{
Task Description—Enter a description for the deployment task.
7.
Click Finish.