H3C Technologies H3C Intelligent Management Center - Manual (Page 52)

44
The configuration window appears.
4. Enter a policy name, a maximum of six characters.
5. Select an 802.1p priority value from the 802.1p list.
6. Click OK.
Deleting a DSCP-802.1p mapping
Perform this task to delete the policy name and mapped 802.1p priority value of a DSCP value.
To delete a DSCP-802.1p mapping:
1. Access the QoS Configuration Info page.
2. Click the DSCP/802.1p tab.
3. Click the Undeploy icon in the Operate column for the target DSCP value.
A confirmation dialog box appears.
4. Click OK.
Service Priority
This function configures the priority and service parameters for each SSID on an HP MSM wireless device.
The Service Priority tab page appears only for HP MSM wireless devices. This tab page displays all
SSIDs on the device in a list and the priority and service parameters for each SSID. You can configure
parameters directly in the list and save the configured parameters.
SSID configuration list buttons
• Refresh—Refresh the SSID configuration list.
SSID configuration list contents
• SSID—Name of the SSID.
• Priority Mechanism—Select a priority mechanism used by the SSID. Options are 802.1p, DiffServ,
Very-High, High, Normal, Low, ToS, and Disable.
• Priority Marking—Enable or disable priority marking for packets. Options are Enabled and
Disabled.
• Custom Default Bandwidth Level—Select a default bandwidth level for users who access the
network through the SSID. Options are Very-High, High, Normal, and Low. When multiple SSIDs
are configured with the same bandwidth level, these SSIDs share the bandwidth for that bandwidth
level.
• Custom Default Queue Rate—Specify whether to set the default rate for users. If you select Enabled
for this option, configure the following parameters:
{
Default Max. Tx Rate—Specify the maximum rate at which users can transmit traffic.
{
Default Max. Rx Rate—Specify the maximum rate at which users can receive traffic.
• Save Configuration—Click the Save link to save the configured parameters for the SSID.
Rate Configuration
This function configures the parameters for the bandwidth levels specified on the Service Priority tab
page. The Rate Configuration tab page appears only for HP MSM wireless devices.