H3C Technologies H3C Intelligent Management Center - Manual (Page 23)

15
5 Managing QoS devices
QoSM allows you to manage QoS-capable devices and provides the following management functions:
• Device/interface QoS capability set—Allows you to view device or interface's support for QoS
features before deploying QoS configurations.
• QoS configuration information—Allows you to view existing QoS configurations on a device and
its interfaces and to deploy or quickly undeploy QoS configurations.
• Baseline and auditing—Informs you of QoS configuration changes on a device or interface.
Through the preceding management functions, you can perform the following task in different phases of
QoS configuration deployment:
• Learn about a device's support for QoS features and existing QoS configurations on the device
before deploying QoS configurations.
• Deploy QoS configurations directly or by using deployment tasks.
• Check whether QoS configurations are successfully deployed and monitor QoS configuration
changes on the device.
Accessing the QoS Device page
The QoS Device page displays all QoS-capable devices managed by IMC in a list and is the entrance
for some QoS management functions.
To add a device to the device list:
1. Add the device to IMC.
2. Configure correct SNMP settings for the device.
3. Synchronize the device.
To access the QoS Device page:
1. Click the Service tab.
2. From the navigation tree, select QoS Manager > QoS Device.
The QoS Device page appears.
QoS Device list contents
{
Status—Current status of the device.
{
Device Label—Label of the device.
{
Device Model—Model of the device.
{
IP Address—IP address of the device. If the device has multiple IP addresses, this field displays
the IP address entered when the device was added to IMC.
{
Polling Result—Synchronization result of device configuration information. The failure cause is
indicated if the result is failure.
{
Audit Status—Audit status for the device. QoSM audits each device by comparing the current
QoS configurations on the device with the baseline set for the device. If no baseline is set for the
device, No baseline is displayed. If a baseline is set for the device, Consistent or Inconsistent is
displayed.