H3C Technologies H3C Intelligent Management Center - Manual (Page 61)

53
Match Type Description Parameters
MAC Address
Use a MAC address as the
match criterion.
• Direction—Select a direction. Options are
Source and Destination.
• MAC Address—Enter a MAC address as the
match criterion.
RTP Port
Use an RTP port range as
the match criterion.
• StartRTP—Enter a start RTP port number in the
range of 2000 to 65535.
• EndRTP—Enter an end RTP port number in the
range of 2000 to 65535.
Inbound Interface
Use an input interface as
the match criterion.
InboundInterface—Enter the description of an
interface where packets are received.
Drop Priority
Use drop priority values as
the match criterion.
Drop Priority—Select one or more drop priority
values by clicking the icon. Options are 0, 1,
and 2.
ATM_CLP
Use the CLP bit value as
the match criterion. ATM_CLP—Select a CLP value as the match
criterion for ATM cells. Options are 0 and 1.
FR_DE
Use the DE value as the
match criterion. FR_DE—Select a DE value as the match criterion for
Frame Relay packets. Options include only 1.
VLAN ID
Use VLAN IDs as the
match criterion.
VLAN ID—Enter one VLAN ID or multiple VLAN IDs
separated by commas (,). Valid VLAN IDs are 1 to
4094.
QoS Local ID
Use a QoS local ID as the
match criterion. QoS Local ID—Enter a QoS local ID as the match
criterion.
Service VLAN ID
Use service provider
VLAN IDs as the match
criterion.
Service VLAN ID—Enter one service provider
VLAN ID or multiple service provider VLAN IDs
separated by commas (,). Valid VLAN IDs are 1 to
4094.
Protocol
Use a protocol type as the
match criterion.
Protocol—Select a protocol type as the match
criterion. Options are IPv4, IPv6, and BT.
Local Precedence
Use local precedence
values as the match
criterion. Local Precedence—Select one or more local
precedence values by clicking the icon. Valid
values are 0 to 7.
c. Click OK to add the configured match criterion and close the current window.
To add the configured match criterion and continue to add another match criterion on the
current window, click Create&Go.
To cancel the configured match criterion and close the current window, click Cancel.
5. On the Add QoS Classifier page, click OK.
Modifying a classifier
You can modify user-defined classifiers.
To modify a classifier:
1. Access the classifier list page.
2. Click the Modify icon for the classifier that you want to modify.
The Modify QoS Classifier page appears.