H3C Technologies H3C Intelligent Management Center User Manual
Page 50
42
Match criterion
type
Description Parameters
IPv6 TCP Port
Number
Match the IPv6 TCP port
number of packets.
If you have not selected Display Range Setting,
configure one IPv6 TCP port number.
•
Port (IPv6 TCP)—Enter a port number.
If you have selected Display Range Setting,
configure an IPv6 TCP port range.
•
Port (IPv6 TCP)—Enter a start port number for
the port range.
•
End Port (IPv6 TCP)—Enter an end port
number for the port range.
IPv6 UDP Port
Number
Match the IPv6 UDP port
number of packets.
If you have not selected Display Range Setting,
configure one IPv6 UDP port number.
•
Port (IPv6 UDP)—Enter a port number.
If you have selected Display Range Setting,
configure an IPv6 UDP port range.
•
Port (IPv6 UDP)—Enter a start port number for
the port range.
•
End Port (IPv6 UDP)—Enter an end port
number for the port range.
IPv4 Address
Match the IPv4 address of
packets.
If you have not selected Display Range Setting,
configure one IPv4 address.
•
IP (IPv4)—Enter an IPv4 address.
If you have selected Display Range Setting,
configure an IPv4 subnet.
•
IP (IPv4)—Enter an IPv4 subnet address.
•
IP mask (IPv4)—Enter a mask length for the
IPv4 subnet address.
IPv6 Address
Match the IPv6 address of
packets.
If you have not selected Display Range Setting,
configure one IPv6 address.
•
IP (IPv6)—Enter an IPv6 address.
If you have selected Display Range Setting,
configure an IPv6 subnet.
•
IP (IPv6)—Enter an IPv6 subnet address.
•
IP mask (IPv6)—Enter a mask length for the
IPv6 subnet address.
Protocol
Match the protocol type of
packets.
Select a protocol from the Protocol list. Options
are IP, IPX, ARP, AppleTalk, SNA, and NetBEUI.
Only the 802.1p priority can be configured
when this match criterion type is selected.
DSCP
Match the DSCP value of
packets.
Select a DSCP value from the DSCP list. The value
range is 0 to 63.
Only the DSCP priority can be configured when
this match criterion type is selected.
IP-Precedence
Match the IP precedence value
of packets.
Not configurable.
VLAN ID
Match the VLAN ID of packets. Enter one VLAN ID in the VLAN ID field.