Displaying running status data – H3C Technologies H3C SecPath L1000-A Load Balancer User Manual
Page 49
41
Comware Software, Version 5.20, Feature 3722
Copyright (c) 2004-2013 Hangzhou H3C Tech. Co., Ltd. All rights reserved.
H3C SecPath L1000-A uptime is 0 week, 0 day, 0 hour, 1 minute
CPU type: XXXX
4096M bytes DDR2 SDRAM Memory
4M bytes Flash Memory
PCB Version:Ver.B
Back Board PCB Version:Ver.A
Logic Version: 3.0
Basic BootWare Version: 1.05
Extend BootWare Version: 1.05
[FIXED PORT] CON (Hardware)Ver.B, (Driver)1.0, (Cpld)3.0
[FIXED PORT] GE0/0 (Hardware)Ver.B, (Driver)1.0, (Cpld)3.0
[FIXED PORT] GE0/1 (Hardware)Ver.B, (Driver)1.0, (Cpld)3.0
[FIXED PORT] GE0/2 (Hardware)Ver.B, (Driver)1.0, (Cpld)3.0
[FIXED PORT] GE0/3 (Hardware)Ver.B, (Driver)1.0, (Cpld)3.0
[FIXED PORT] GE0/4 (Hardware)Ver.B, (Driver)1.0, (Cpld)3.0
[FIXED PORT] GE0/5 (Hardware)Ver.B, (Driver)1.0, (Cpld)3.0
[FIXED PORT] GE0/6 (Hardware)Ver.B, (Driver)1.0, (Cpld)3.0
[FIXED PORT] GE0/7 (Hardware)Ver.B, (Driver)1.0, (Cpld)3.0
[FIXED PORT] GE0/8 (Hardware)Ver.B, (Driver)1.0, (Cpld)3.0
[FIXED PORT] GE0/9 (Hardware)Ver.B, (Driver)1.0, (Cpld)3.0
[FIXED PORT] GE0/10 (Hardware)Ver.B, (Driver)1.0, (Cpld)3.0
[FIXED PORT] GE0/11 (Hardware)Ver.B, (Driver)1.0, (Cpld)3.0
[SUBCARD 1] The SubCard is not present
[SUBCARD 2] The SubCard is not presen
Displaying running status data
For diagnosis or troubleshooting, you can use the display diagnostic-information command in any view
to bulk collect running data for multiple modules, rather than using separate display commands to
collect running status data module by module.
1.
Save running status data for multiple feature modules.
Save or display diagnostic information (Y=save, N=display)? [Y/N]:y
Please input the file name(*.diag)[flash0:/default.diag]:aa.diag
Diagnostic information is outputting to flash0:/aa.diag.
Please wait...
Save successfully.
2.
Save the file aa.diag to the PC:
# Execute the save command in any view to save the current configuration of the L1000-A.
The current configuration will be written to the device. Are you sure? [Y/N]:y
Please input the file name(*.cfg)[flash0:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
flash0:/startup.cfg exists, overwrite? [Y/N]:y