H3C Technologies H3C SecPath L1000-A Load Balancer User Manual
Page 31
23
IMPORTANT:
•
Identify the mark on the console port and make sure you are connecting to the correct port.
•
The serial ports on PCs do not support hot swapping. If the L1000-A has been powered on, always
connect the console cable to the PC before connecting it to the L1000-A, and when you disconnect
the cable, first disconnect it from the L1000-A.
Configuring communication parameters on the terminal
1.
On the PC, select Start > Programs > Accessories > Communications > HyperTerminal.
2.
Enter a name for the connection and click OK.
Figure 21 Creating a HyperTerminal connection
3.
Select the serial port used to connect to the L1000-A and click OK.
Figure 22 Selecting the serial port
This manual is related to the following products: