Configuring sms alarming, Configuration guide, Managing filters – H3C Technologies H3C SecCenter IPS Manager User Manual
Page 30
24
Item Description
Send to
Optional
Type an email address and click Test. An email will be sent to the email box
for testing.
Configuring SMS alarming
You can specify a phone number to which alarms are to be sent by Short Message Service (SMS)
messages.
Configuration guide
1.
From the navigation tree of the system management component, select SMS Alarm Configuration
under System Config. The SMS alarm configuration page appears, as shown in
.
2.
describes the SMS alarming configuration items.
3.
Click Apply.
Figure 22 Configure SMS alarming
Table 26 SMS alarming configuration items
Item Description
Enable SMS Alarm
Required
Specify whether to enable SMS alarming.
COM Port
Required
Select a COM port for sending SMS messages. The port defaults to COM4.
Baud Rate
Required
Select a baud rate for sending SMS messages.
Send to
Optional
Type a number and click Test. A message will be sent to the phone for testing.
Managing filters
A filter can filter information about IPS devices to present only information that you are interested in
through reports.
By configuring filters, you can specify filtering conditions flexibly.