H3C Technologies H3C S12500 Series Switches - Manual (Page 53)

40
Step Command Remarks
2. Enter DHCP address pool
view.
dhcp server ip-pool pool-name N/A
3. Configure a self-defined
DHCP option.
option code { ascii ascii-string | hex
hex-string | ip-address
ip-address&<1-8> }
By default, no self-defined DHCP
option is configured.
Table 2 Common DHCP options
Option Option name
Corresponding
command
Recommended option
command parameters
3 Router Option gateway-list ip-address
6 Domain Name Server Option dns-list ip-address
15 Domain Name domain-name ascii
44
NetBIOS over TCP/IP Name
Server Option
nbns-list ip-address
46
NetBIOS over TCP/IP Node
Type Option
netbios-type hex
66 TFTP server name tftp-server ascii
67 Boot file name bootfile-name ascii
43 Vendor Specific Information N/A hex
51B
Enabling DHCP
You must enable DHCP to validate other DHCP configurations.
To enable DHCP:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable DHCP. dhcp enable By default, DHCP is disabled.
52B
Enabling the DHCP server on an interface
Perform this task to enable the DHCP server on an interface. Upon receiving a DHCP request on the
interface, the DHCP server assigns an IP address and other configuration parameters from the DHCP
address pool to the DHCP client.
To enable the DHCP server on an interface:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view. interface interface-type interface-number N/A