H3C Technologies H3C S12500 Series Switches - Manual (Page 20)

7
NOTE:
By default, Ethernet, VLAN, and aggregate interfaces are down. To configure such an interface, bring the
interface up by executing the undo shutdown command.
167B
Network requirements
As shown in
659H
Figure 3 , hosts are connected to the switch, which is connected to the router through
interface GigabitEthernet 3/0/1 in VLAN 10.
To ensure secure communications between the router and switch, configure a static ARP entry for the
router on the switch.
Figure 3 Network diagram
168B
Configuration procedure
# Create VLAN 10.
system-view
[Switch] vlan 10
[Switch-vlan10] quit
# Add interface GigabitEthernet 3/0/1 to VLAN 10.
[Switch] interface GigabitEthernet 3/0/1
[Switch-GigabitEthernet3/0/1] port access vlan 10
[Switch-GigabitEthernet3/0/1] quit
# Create VLAN-interface 10 and configure its IP address.
[Switch] interface vlan-interface 10
[Switch-vlan-interface10] ip address 192.168.1.2 8
[Switch-vlan-interface10] quit
# Configure a static ARP entry that has IP address 192.168.1.1, MAC address 00e0-fc01-0000, and
output interface GigabitEthernet 3/0/1 in VLAN 10.
[Switch] arp static 192.168.1.1 00e0-fc01-0000 10 GigabitEthernet3/0/1
# Display information about static ARP entries.
[Switch] display arp static