H3C Technologies H3C S12500 Series Switches - Manual (Page 136)

123
Task Command
Display ICMPv6 traffic statistics (in IRF
mode). display ipv6 icmp statistics [ chassis chassis-number slot
slot-number ]
Display IPv6 TCP traffic statistics (in
standalone mode).
display tcp statistics [ slot slot-number ]
Display IPv6 TCP traffic statistics (in IRF
mode).
display tcp statistics [ chassis chassis-number slot slot-number ]
Display IPv6 UDP traffic statistics (in
standalone mode).
display udp statistics [ slot slot-number ]
Display IPv6 UDP traffic statistics (in IRF
mode).
display udp statistics [ chassis chassis-number slot slot-number ]
Clear IPv6 neighbor information (in
standalone mode). reset ipv6 neighbors { all | dynamic | interface interface-type
interface-number | slot slot-number | static }
Clear IPv6 neighbor information (in IRF
mode).
reset ipv6 neighbors { all | dynamic | interface interface-type
interface-number | chassis chassis-number slot slot-number |
static }
Clear path MTUs. reset ipv6 pathmtu { all | dynamic | static }
Clear IPv6 and ICMPv6 packet statistics
(in IRF mode).
reset ipv6 statistics [ slot slot-number ]
Clear IPv6 and ICMPv6 packet statistics
(in IRF mode).
reset ipv6 statistics [ chassis chassis-number slot slot-number ]
Clear IPv6 TCP traffic statistics. reset tcp statistics
Clear IPv6 UDP traffic statistics. reset udp statistics
For more information about the display tcp statistics command, the display udp statistics command, the
reset tcp statistics command and the reset udp statistics command, see "IP performance optimization
commands."
124B
IPv6 basics configuration example
By default, Ethernet, VLAN, and aggregate interfaces are down. To configure such an interface, bring
the interface up by executing the undo shutdown command.
276B
Network requirements
As shown in
778H
Figure 47 , a host, Switch A, and Switch B are connected through Ethernet ports. Add the
Ethernet ports into corresponding VLANs, configure IPv6 addresses for the VLAN interfaces and verify
that they are connected. Switch B can reach the host.
Enable IPv6 on the host to automatically obtain an IPv6 address through IPv6 ND.
Figure 47 Network diagram