Eneo EKR-32/8 - Manual (Page 98)

4.3.2.3 Commands
Command from PC Meaning Explanation Response
[#Clr+monitor$] Clear In setup mode, with monitor =1, it emulates the
C
key ; in normal mode it resets the alarms
[ok]
[#Ent+monitor$] Enter In setup mode, with monitor =1, emulates the
E
key
[ok]
[#Men+monitor$] Enter setup With monitor=1 enters setup [ok]
[date_time_Setup_$]
[#Buzzforced,active$] Sets off buzzer forced: 1 forces the buzzer, 0 normal operation
active: if forced 1 on, 0 off
[ok]
[#Vid-monitor$] Previous camera monitor : monitor number 1/8 [ok]
[#Vid+monitor$] Next camera monitor : monitor number 1/8 [ok]
[#VidAmonitor$] Automatic sequence monitor : monitor number 1/8 [ok]
[#VidSmonitor,camera$] Manual switching monitor : monitor number 1/8
camera: camera number from 1 to 32
[ok]
[#Poll2$] Serial channel check Communication test : the matrix responds [ok] [ok]
[#Rst+$] Reset Reset from the matrix; settings are not lost [ok]
[#TimR$] Read date/time [date_time$]
[#TimWword1, word2,
word3$]
Set date/time word1: (year % 100)*256 + month
word2: day*256 + hours
word3: minutes*256 + seconds
[ok]
[#Mon?number$] Request for monitor status number: monitor number 1/8
response:
n: monitor number 1/8
S: status N normal, V VCR, U up/down
CC: camera 01/32; ZZ automatic or VCRr
A: N no alarm, A alarm event
[Mon?nSCCA$]
[#Txt-$] Remove text [ok]
[#Txt+$] Insert text [ok]
[#Vers0$] Request for firmware version [firmware version$]
[#ViJD1$] Emulate joystick Emulates movements in menus: down [ok]
[#ViJU1$] Emulate joystick Emulates movements in menus: up [ok]
[#ViJL1$] Emulate joystick Emulates movements in menus: left [ok]
[#ViJR1$] Emulate joystick Emulates movements in menus: right [ok]
• 4. Advanced Functions Page 30/65 MNNCEKR328_0439