Eneo EKR-32/8 - Manual (Page 129)

8.3.13.2 Assignment of the cycling sequence
Two cycling sequences can be assigned to each monitor, one sequence during opening hours and the
other sequence operative when closed. Click on the arrow of the “Opening sequence” ComboBox relating
to the monitor concerned and select the identification number of the chosen cycle. Click on the arrow of
the “Closed sequence” ComboBox relating to the monitor concerned and select the identification number
of the chosen cycle.
In the “Autoreturn” field input the autoreturn time in minutes .
Click on the “<< Back” button to return to the previous screen.
Click on the “>> Next” button to continue.
8.3.14 Alarms
Parameters for 32 alarm contacts can be configured through the software.
When the “alarm contacts” screen opens, a box listing the 32 alarms will be displayed. The alarms are
initially disabled. To enable an alarm, click the alarm required in the “alarm contact” box, on the CheckBox
to the left. The enabling of each alarm contact entails the completing of the screen with the appearance of
parameters that can be configured for each alarm.
• 8. Configuration software Page 61/65 MNNCEKR328_0439
figure 20: alarm contacts
Time interval
ComboBox
(visible only if
timed reset is
selcted)
Normally
Open/Closed
alarm definition Enabling period
of alarm contact Buzzer enabling
Selection of enabled
keyboards for alarm
resetting
Cycle sequence
selection
ComboBox
Camera selection
ComboBox
Action on relay
selection
ComboBox
Scan number
selection
ComboBox
Action
selection
ComboBox
Receiver
selection
ComboBox
Alarm
identification text
Alarm
contact
enabling
Reset mode Action selection
ComboBox