Eneo EKR-32/8 - Manual (Page 121)

8.3.4 Receiver decoding
If you wish to decode the receivers, click on the CheckBox called “Receiver decoding”. The box “Receiver
assignment” appears where, next to each camera, there is a field with an UpDown in which to input the
receiver's ID number (see figure 13).
8.3.5 Auxiliary lines
To configure the auxiliary lines auxa and auxB click on the CheckBox called “Use aux lines”. The two
auxiliary line configuration boxes appear.
For each auxiliary line, select the protocol by clicking on the arrow of the “Protocol” ComboBox.
Select the baud rate by clicking on the arrow of the ComboBox called “Baud”. The "Baud" ComboBox
cannot be seen unless a protocol has been set.
Refer to figure 14.
Click on the “<< Back” button to return to the previous screen.
Click on the “>> Next” button to continue.
• 8. Configuration software Page 53/65 MNNCEKR328_0439
figure 13: receiver encoding, auxiliary lines
Click to bring up
the “Receiver
Assignment” box
UpDown field in which to input
the ID number of the receiver
corresponding to camera 9
Click on the “Use Auxiliary
Lines” CheckBox to
configure the auxiliary lines
Baudrate selection
ComboBox
The “Baud” ComboBox
does not appear due to
the fact no protocol has
been set
Protocol selection
ComboBox