Eneo GLS-2302H User Manual
Page 48
48
• Change the Application Setting – Motion Detection
Please follow the steps below to enable changes in the motion detection function of the alarm through the network as
necessary.
Set the motion detection:
. Click on the
Motion Detection button on the left side of the Alarm to enter the „Motion Detection” page.
. Click and drag the mouse across a targeted zone to draw a red rectangle on the image (coordinates provided
below).
NOTE: You can set more than one targeted zone depending on your requirement.
. Enables / disables the motion detection function.
4. Set up the signal level.
5. Click on the
Submit button to submit the new setting of the recording.
Description of function keys:
Sensitivity
The sensitivity bar allows you to specify how much movement is required to trigger the
motion detection.
Percentage
Adjusting the percentage allows you to set a requirement on how much of the motion
window must be filled by movement. For example: If you set this to 50%, then the se-
lected window must be half filled by a moving object before it triggers motion detection.