Eneo GLS-2302H - Manual (Page 11)

6. In 5 to 0 seconds, a message reading „UPDATE PROCESSING” will show up on the screen on a blue back-
ground; if not, please check out steps to 6 carefully or else inform your technical support while ignoring the
following steps.
7. DO NOT power off the Video Server while this update process is running until the message „UPDATE OK RESET
PLEASE” appears on the screen; it might take 5 to 0 seconds to appear.
8. If the message „UPDATE NG RESET PLEASE” appears rather than „UPDATE OK RESET PLEASE”, please write down
the error messages shown on the screen and inform your technical support, while ignoring the following steps.
9. Power off the Video Server when this update process is finished, then remove the SD card from the Video Server.
0. Reconnect the Ethernet cable to the RJ-45 port if necessary.
. Power ON the Video Server and it will work normally if the entire update procedure goes correctly.
. Verify the version of the system software.
WARNING:
1. Steps 1 to 3 have to be done on a PC.
2. Make sure the file of UPDATE.BIN is a correct one in step 3, or the VIDEO SERVER will not work normally
after being updated.
3. If the power of the VIDEO SERVER is suddenly lost in step 8, please remove the SD card first and turn on
the VIDEO SERVER next to test its operation. If the VIDEO SERVER remains working normally, please go
back to step 4; otherwise, please inform your technical support.
4. In step 10, if the SD card is not removed and the Video Server does not get online as well, the updating
process must be repeated again after rebooting the Video Server.
5. Make sure that the SD card is inserted in a correct position in step 5, or the Video Server will suffer
permanent physical damage.
6. If the message „CSUM ERROR” appears in step 8, it implies a problem in the file of UPDATE.BIN.
7. Don’t interrupt the process while the unit is updating itself; proceed with an SD card not including any
system software of the unit, or else the unit will crash.
5. Network Configuration
5.1 Cable Connections
Please follow the instructions below to connect your Video Server to a computer or a network and to choose a proper
RJ-45 cable configuration for connections.
Physical specification of RJ-45 cable for Ethernet
Wire Type Cat. 5
Connector Type RJ-45
Max. Cable Length 00m
Hub Wiring Configuration Straight Through
PC Wiring Configuration Straight Through