Eneo PXC-2080CS - Manual (Page 96)

Web Admin User Manual
- 41 -
After configuration is finished, click Apply button to save the setting. If you click Default
button, the entire configuration will be reset to the original values.
5.4. DI (Sensor Input) / DO (Alarm Output)
Select DI/DO from Device Configuration menu to configure Sensor Input and Alarm Output.
After the setting up, select DI Status/DO Control on Device Configuration menu to configure
the behavior of those Input and Output ports.
DI/DO functionality can be set to either Normal Open or Normal Closed type as follows.
• Normal Open Type: Normal is OPEN, and goes CLOSED when triggered by an event.
• Normal Close Type: Normal is CLOSED, and goes OPEN when triggered by an event.
DI/DO Setup DI/DO Control
Note: Make sure the type of the sensor and use it correctly to the type. If a
Sensor Input is not used, it must be set to Normal Open Type to avoid a
false input.