Eneo PXC-2080CS - Manual (Page 51)

Smart Viewer User's Manual
XXI
Speed
Adjust the rate of camera motion. It can be between 1 and 16, and higher
number is faster.
Controls in 8 directions: Up, Down, Right, Left, 4 Diagonals.
Adjust zooming. ' + ' for zoom-in and ' - ' for zoom-out.
Adjust focus. '
+
' for focus far, '
-
' focus near.
Control Auto Pan for the model supporting Auto Pan feature.
Preset Call
Move the camera automatically to the preset position as it is configured in PTZ
control on Server.
PTZ Move Mode
Moving cameras in two different modes: Step and Continuous modes.
Step mode: Camera moves as much as previously defined each time. This mode
is effective for remote cameras with slow network condition.
Continuous mode: Camera keeps moving while direction control buttons is
pressed. This mode is effective for local camera with fast responsiveness.
Provides an extended use of PTZ. Works only with registered Groups and Tours.
It can be used for control of camera power, light, AUX1, and AUX2.
Assign group numbers at , and run Group.
Run Tour with Tour configured.
Control the camera power.
Turns lights On or Off.
Control AUX 1.
Control AUX 2.
Note: To enable PTZ bar for use, it is required to make PTZ function active in admin page
in advance.