Eneo PXC-2080CS - Manual (Page 122)

Web Admin User Manual
- 67 -
Below is an example of configuring the recording condition, which means “ Video is recorded if
Alarm is activated or Motion is detected, on Saturday and Sunday every week .” If time condition
is not specified, it is taken as setting 24 hours. If date is not specified, it is taken as setting all
the months and weeks. Click the Back button if you want to return to previous page without
saving. Click the Save button to save the change and return to previous page.
Category Item Description
Select
Mode
Always Recording is enabled all the time.
Schedule Only Recording is done by configured schedule.
Event Only Recording is controlled by configured event.
Schedule and Event
Recording is controlled by both schedule and
event.
Schedule
Week Set day of week
Time Set time
Date Set date
Event
Alarm Sensor
Each of 1, 2, 3, 4 refers to the sensor number, and
checked when Event-Driven Recording is selected.
If all the four sensors are checked together,
recording is enabled only when all four sensor are
activated.
Motion Detection
Each of 1, 2, 3, 4 refers to the sensor number, and
checked when Motion Detection Recording is
selected.
If all the four sensors are checked together,
recording is enabled only when all four sensor are
activated.
When Hardware motion detection is used, you
should set the detection area in Camera & Motion
section.
Camera Connected
Recording is enabled when camera signal is
detected.
Camera
Disconnected Recording is enabled when camera signal is not
detected.