Eneo PXC-2080CS - Manual (Page 83)

Web Admin User Manual
- 28 -
Multicast
Address Address for multicast video transfer.
The multicast address 0.0.0.0 is for stopping multicast.
Multicast
Port
Port number for viewing the video with a multicast address
To use ONVIF protocol, RTP/RTSP must be enabled.
4.9. SNMP Setup for Cameras
SNMP (Simple Network Management Protocol) is a protocol to monitor and configure network
status of a network device. SNMP V1 and V2 are supported over MIB2 standard, and few
functions are not supported.
SNMP Trap can function when SNMP V1/V2 is enabled.
SNMP V1/V2
Enable: Start SNMP service
Disable: Stop SNMP service
Trap
Enable: Start SNMP Trap service
Disable: Stop SNMP Trap service
Destination IP
Address
IP Address to receive SNMP Trap messages.
Trap
Community
Key value used in SNMP Trap e.g.) public
Available
Traps
Type of SNMP Trap message
1. Cold Start : When SNMP starts
2. Authentication Failure : When key value of SNMP query