Eneo PXC-2080CS - Manual (Page 8)

7
5. Installation and commissioning Instructions
•
Make sure the power is removed before the installation.
• After all connections are finished properly, follow the order for applying power.
a) Plug the network cable into RJ-45 Ethernet Port at the rear panel.
If PoE is the unique power, there will be no need to connect Power terminal.
b) When DC12V or AC24V Local power is necessary, first connect the low voltage (DC12V or AC24V),
then plug the AC adapter to AC outlets to avoid an improper reset from power jitter and a damage
from the surge voltage when no load.
※ When PoE and Local power are connected, Local power has priority.
5.1. Attaching the lens
• Remove the Dust Protection cap from the lens mount
• Screw the lens onto the camera firmly.
• Plug the lens plug into the lens connector
5.2. Setting the back focus
The proper back focus adjustment is essential for the motorized zoom lens to get the all time sharp focus
when zooming in and out by the remote control.
For easier and better adjustment, this camera provides FOCUS ADJUST menu which prevents from the
mistake of the focus adjustment.
With enabling FOCUS ADJUST menu, follow the procedure to get the best back focus adjustment.
1. Set the lens for the zoom position to WIDE and the focus position to INFINITE
( ∞ )
2. Shoot the object departing from about 10Meters.
3. Adjust ⑤ Back focus Adjustment with 3mm Hex L-wrench until the optimum focus is achieved.
4. Set the lens for zoom position to TELE and adjust the lens focus for best focus.
5. Set the lens for zoom position to WIDE again, check if the focus adjustment was the best.
If not, re-adjust ⑤ Back focus Adjustment slightly.
5.3. Installation
The camera has a 1/4” thread insert on its top and bottom side for mounting the camera to a tripod or the
wall or ceiling with a corresponding mount.