ARM Electronics DVRHD OSD - Manual (Page 50)

OSD Setup Manual
49
Configuration ʳ ʳ ʳ ʳ ʳ ʳ
Users can restore factory default setting, import/ export configuration in the Configuration
menu. Select from the main menu and press ENTER. The following menu
is displayed. Items in this menu are described in the following subsections.
Configuration
Load Factory Default
Import Config
Export Config No
< Load Factory Default >
This item is used to load the factory default setting. Select to restore the factory
default setting from the read-only memory, or select to cancel.
< Import Config >
This item allows users to load a DVR configuration that was saved in an external drive. To
import a configuration that was previously exported, make sure the device with the saved
configuration is connected to the DVR. Select from the Configuration
menu and press ENTER. The following menu is displayed.
Import Config
Config Name
xxxx-xxxx
xxx-xx Select
No
No
Press UP/ DOWN to select one of the available configuration files, and choose to
start importing the configuration.
NOTE: If the record mode and/or number of IP cameras of the imported configuration
are different from the DVR’s configuration, the following message will be displayed.
Warning!! System will reboot if
record mode and/or IP camera number
differ.
ENTER: Yes ESC: No
NOTE: DO NOT remove the external device before the DVR completely reboots,
otherwise it will be formatted.