ARM Electronics DVRHD OSD - Manual (Page 35)

OSD Setup Manual
34
When the settings cannot be applied, the following message will be
displayed. Try to reduce the resolution or FPS of the IP camera. Note that
the login account of the IP camera should have administrator authority.
Cannot set the IP device
Otherwise, the setting is completed.
NOTE: After changing any item under Device Setup menu, users
MUST set to to apply the changes, or the settings
will remain unchanged.
„ Activated
Access this item and select to activate the connection to the IP camera. To
deactivate the connection, select
NOTE: Once the connection to the IP camera is activated, menu items
, , will be grayed out and
cannot be accessed.
„ Status
After the connection to the IP camera is activated, users can check the connection
status. The menu will be shown as below.
Status
Model
Streaming Format
Resolution
PPS
Bandwidth
Pkg. lost rate ****
MJPEG
720*480
10
20 KB/Sec
0.1%
The information shown on the monitor is “ready only”.