ARM Electronics DVRHD OSD - Manual (Page 27)

OSD Setup Manual
26
Enter this item to add IP cameras to the DVR. Setting this item to <0> will make DVR act as
a traditional analog DVR. Select any other number to allow the corresponding connection of
IP cameras to the DVR.
After a number is selected, the following message will be displayed. Press ENTER to apply
the changes, or ESC to exit.
Notice!!
DVR must be reboot to apply the change
ENTER: Yes ESC: No
NOTE:
1. The existing database will NOT be re-formatted after switching on this function.
2. Alarm I/O, Motion detection function, and audio of the IP camera are currently
NOT supported.