ARM Electronics DVRHD OSD - Manual (Page 39)

OSD Setup Manual
38
< Per Camera Config >
This sub-menu is used to set the Day / Night / Weekend PPS and recording quality for each
individual channel. must be set to in order to access these
related settings. The menu is displayed as below in Record mode: 720×240@60PPS in
NTSC / 720×288@50PPS in PAL.
Per Camera Config
Cameral Select
Normal PPS
Normal Qlty
Event Max PPS
Event Qlty
Event Act
Day
7.5
Mid
30
Best
Both
Night
7.5
Mid
30
Best
Both
CH1
Weekend
7.5
Mid
30
Best
Both
„ Camera Select
The item is used to select a desired channel for setting the parameters. Move the
cursor to and press ENTER, then select a channel using UP /
DOWN keys. Press ENTER again to confirm the selection.
„ Normal PPS
Normal PPS is used to set the recording rate for normal status.
Please note that the total normal PPS of all channels cannot exceed the maximum
PPS of each Record mode. To increase one channel’s PPS, others’ may have to
be reduced first. Event PPS is not restricted to this rule, since a smart event
scheduler will handle to the total PPS with a correct weighting. For example, if
channel 1 is set to event mode with 30PPS, the remaining 30 PPS will be equally
distributed to other 15 channels, which means each channel will be set to 2 PPS.
„ Normal Qlty
This item is used to set the picture size for normal status recording. The available
options are: , , , and .
„ Event Max PPS
is used to set the event recording rate for Event status. Usually,
the Event PPS is set equal to or greater than the Normal PPS. The setting is
depending on users’ application. If the Event PPS is set to <0>, the DVR will not
record event video when alarms triggered.