Welltech WG5260 V.6.2 - Manual (Page 77)

Welltech Computer Co., Ltd.
WellGate 5260 User Guide – V6.2.0 - 77 -
• Min Retry Interval (second): This is the initial retry interval. Each retry will
multiple 2. For example, the Min Retry Interval is 10 and Max Retry Interval
is 600. The retry sequence will be 10, 20, 40, 80, 160, 320 seconds.
• Max Retry Interval (second): This is the max time to wait before attempting
a retry.
• Max Adjust Time (second): If this is zero, the SNTP client will be willing to
apply any size time adjustment. If this is non-zero, then any time adjustment
greater than this will be considered an error.
• NTP Server Port: This is the port number the SNTP client will attempt to
connect to on the time server. The default value is 123.
• Local NTP Port: This is the port number that will use to listen for replies from
the server. The default value of 0 means use a random port number.
• Packet Error Check: If this is disabled, then the validity checks are
suppressed. The default value is enabled.
Network
DNS Server Setting:
Step 1: After successfully logon to the system, we need to change the network
configuration. Click Control > Network to setup the network parameters
as figure 8.3-1.
Figure 8.3-1
Parameter Description:
• Primary DNS Server: Primary DNS Server IP network
• Secondary DNS Server: Secondary DNS Server IP network
• Host Name: Host name used to register to DNS Server
• Domain Name: Domain name used to
• Dynamic DNS Registration: Enable Dynamic DNS registration or not
SNMP
Community
Start path: Click Control>SNMP>Community