Welltech WG5260 V.6.2 - Manual (Page 42)

Welltech Computer Co., Ltd.
WellGate 5260 User Guide – V6.2.0 - 42 -
Figure 5.3-4
Parameter Description:
• Name: Name of the prefix
• Tel/Prefix: The matched prefix
• Trans Address: Peering Signaling Address
- H.323 Call: 192.168.5.102 or 192.168.5.102:1720
- SIP Call: sip:[email protected] or sip:[email protected]:5060 or
sip:[email protected]
• Use SIP Proxy: The Proxy ID set in SIP > Proxy.
• Priority: The priority for this entry
• Remove Prefix: Remove the prefix or not
• Add Prefix: Add the entered prefix
• DNIS DM Group: The DM group to be used after remove prefix and add
prefix.
• Working Time: Set the working time
• Working Day: Select the working day
• Allow No ANI: Allow no ANI (anonymous call) or not
• Trusted Network (SIP Only): Does this peering gateway/Proxy is a trust
network or not? When it is a trust network, the RFC 3325 or CISCO
remote-party-id will be used.
- Mode: The trust network can support P-Assert-ID (RFC 3325),
Remote-Party-ID (CISCO) or both modes. When set to both, both P-
Assert-ID and Remote-Party-ID will be added together.
- Privacy:
Auto: This is the default setting. The privacy header will be set
based on the incoming call attribute (Q931 attribute or SIP header).
Full (ID): The privacy header will be set to ID for RFC 3325 or full
for CISCO.
Off (None): The privacy header will be set to none.
- Screen: The Remote-Party-id’s screen header:
Auto: The screen header will be set based on the incoming call
attribute.