beautypg.com

Welltech WG5260 V.6.2 User Manual

Page 136

background image

Welltech Computer Co., Ltd.

WellGate 5260 User Guide – V6.2.0

- 136 -

dial-peer voice 300 voip
destination-pattern 20T
rtp payload-type nte 110
voice-class codec 88
session protocol sipv2
session target ipv4:192.168.5.205
dtmf-relay rtp-nte
fax-relay ecm disable
fax rate 14400
fax protocol t38 ls-redundancy 2 hs-redundancy 2 fallback cisco
no vad

dial-peer voice 250 voip
application session
destination-pattern 2T
voice-class codec 2
session protocol sipv2
session target sip-server
fax rate 14400
fax protocol t38 ls-redundancy 1 hs-redundancy 1 fallback cisco

sip-ua

line con 0
speed 115200
line aux 0
line vty 0 4


Q9. WG5260 cannot register to Cisco gatekeeper.
Answer:

a. Make sure GK IP and port number is correct.
b. If the gatekeeper can only allow predefined endpoint, make sure

WG5260 has it defined.

c. If you need prefix support, set it on GK.


Q10. External Radius server does not work.
Answer:

a. Make sure “VoIP Authentication method” is set to “external AAA”.
b. Make sure “AAA” component is used in the call flow editor to take effect.
c. Make sure Radius server IP and port for authentication & billing are

correct.


Q11. Internal Radius server does not work.
Answer:

a. Make sure “VoIP Authentication method” is set to “internal AAA”.
b. Make sure “AAA” component is used in the call flow editor to take effect.
c. Make sure only debit user is used for VoIP caller.


Q12. PSTN hunting Group does not work.