Welltech WG5260 V.6.2 User Manual
Page 72
Welltech Computer Co., Ltd.
WellGate 5260 User Guide – V6.2.0
- 72 -
• Description: Description of Hunting Group
• Hunting Method: Route selection
- Random: Random select a trunk within this hunting group
- Priority: Select a trunk by priority. (Priority 1 has lowest priority; 9 has
highest priority)
- Round Robin: Call is hunting rotationally
• Trunk Group Name: Trunk group name used for least cost route according
to draft-ietf-iptel-trunk-group-10.txt
Start Path: Configuration>Routing Plan>Hunting Group>Detail
Figure 7.8-2
Parameters Description:
Group: 1 Description: 0932
• Interface ID: Interface ID
• Trunk ID: trunk id for group 1
• Priority:
Trunk
priority
• Channel Mask: Channel mask for incoming or outgoing calls (refer
)
☺
Note: When a Route Plan channels mask is cooperated to trunk
channel mask to decide the channel availity 17~31 channels are
available:
Example 1:
Trunk ID: 0 channel mask: 0xffffffff
Route Plan channel mask: 0x0000ffff
Available channel: 0x0000ffff (17~31) channels.
Example 2:
Trunk ID: 0 channel mask: 0xffff0000
Route Plan channel mask: 0xffc00000
Available channel: 0xffc00000 (1~9) channels.
Call Routing
The call routing can be used for hunting a PSTN trunk by prefix.
Start Path: Configuration>Routing Plan>Call Routing
Figure 7.8-3
Parameters Description:
• Group ID: Select the T1/E1 according to the selection of Hunting Group ID
when dialed number is matched
• Number To Route: The dialed telephone number to be matched