Welltech WG5260 V.6.2 - Manual (Page 60)

Welltech Computer Co., Ltd.
WellGate 5260 User Guide – V6.2.0 - 60 -
Basic Parameter Description:
• Register To Gatekeeper: Register to Gatekeeper or not
o
Yes: Register to GK
o
No: Not register to GK
• Gatekeeper IP: Gatekeeper IP Address
• Gatekeeper RAS: UDP Port number listened on Gatekeeper (default:
1719)
• E.164 Tel: Telephone number to be registered to Gatekeeper
• Register H.323 ID: H.323 alias name to be registered to Gatekeeper
• Register Time To Live (sec): The registration maximum time to live
setting when registered to the Gatekeeper
• Response Timeout (RAS)(sec): The maximum wait time for response
based on RAS signaling from sending call setup signal out
• Response Timeout (Q.931)(sec): The maximum wait time for response
based on Q.931 information from sending call setup signal out
• Connect Timeout (Q.931)(sec): The maximum wait time for connection
(answer) from dialing out the destination number
• DTMF Relay: DTMF transfer type selection
o
RTP Relay (RFC 2833): DTMF relay via RTP packet (RFC2833
standard)
o
DTMF transparent: transmitter DTMF over voice channel
o
H.245 Signal input: DTMF relay via H.245 user signal input
o
H.245 Alphanumeric: DTMF relay via H.245 Alphanumeric signal
o
Q.931-User Information: DTMF relay via Q.931 User to user
information
• Fax Transmission: Fax transport type selection
o
Transparent mode: Transparent mode (by voice packet)
o
T.38 Fax Relay (H.245 mode): T.38 Fax relay (H.323 Annex D)
o
By Pass: Allow the fax pass mode (bypass to G.711 A-law or u-law).
• Fast Connect Mode: Connection of H.323 call fast mode
o
Disable: Don’t use Fast Start.
o
Enable Fast Start Both Site: Use Fast Start for incoming call and
outgoing H.323 calls
o
Fast Start-H.323 Incoming Call Only: Enable Fast Start for H.323
incoming calls only
o
Fast Start-H.323 Outgoing Call Only: Enable Fast Start for H.323
outgoing calls only.
o
Early H.245: Use Early H.245
• H.245 Tunneling: Transfer the H.245 message over the Q.931 channel
• FS Enable 1-6 (Codec Priority 1-6): Enable Fast Start codec selection for
each codec
• Inbound DM Group: Digit Manipulation Group for H.323 incoming calls
• Outbound DM Group: Digit Manipulation Group for H.323 outgoing calls
Advance H.323 Configuration:
Start Path: Configuration>H.323 >Advance