Welltech WG5260 V.6.2 - Manual (Page 14)

Welltech Computer Co., Ltd.
WellGate 5260 User Guide – V6.2.0 - 14 -
Network Configuration
Step 1: After successfully logon to the system, we need to change the network
configuration. Click Control > Network to setup the network parameters
as figure 2.2-1.
Figure 2.2-1
Step 2: Enter the deserved IP address, Submask and default gateway. Apply
the change by clicking apply button as figure 2.2-2.
Figure 2.2-2
Step 3: When screen shows “Setup network configuration successfully!” It
means the IP Network setting is successfully changed as figure 2.2-3.
Figure 2.2-3
☻Note: “Network Control” takes around 5-second to apply the new
network configuration. Please logon again with new IP address
after 5 seconds.
System Time Configuration
Step 1: When re-logon to the new IP address, the next is to setup the system
time zone. Click Control > System Time to setup the system time zone