Wavetronix Command Collector (CMD-DCx) - User Guide - Manual (Page 115)

114 CHAPTER 9 • DRIVER REFERENCE
˽ Baud Rate – Baud rate for modem connection (Mikros devices are modem commu-
nication only).
˽ Timeout – Time in milliseconds Collector will attempt to make a modem connection
before returning.
˽ Retry Count – If Collector cannot make a modem connection in the timeout period,
(or if it contains a NO CARRIER error), it will try again this number of times before
abandoning the collection attempt completely.
˽ Clear Data – Mikros has the ability to remove data from the onboard memory after col-
lection. If checked, Collector will clear the device buffers after successfully download-
ing data; if unchecked, the previous data will remain.
˽ Daytime Collection – If unchecked, the Diamond driver will ignore data collection
commands during daytime hours (7 a.m. to midnight).
Class Mappings
Some Mikros devices have special PRG20/PRG23 or Heavy/Regular Vehicle collection en-
abled. This allows you to decide how those special vehicle classes are mapped to the stan-
dard Class1 to Class13 Collector classes. Ignore means that data is not mapped to any of the
thirteen classes, and is ignored.
Diamond
Diamond traffic products specialize in traffic measurement and count up to four lanes of
traffic using road tube, piezo, and/or loop presence sensors (see Figure 9.8).
Figure 9.8 – Diamond Custom Panel
Custom Fields
˽ Location – A description of the place where the sensor is installed, which can be a
name or geographic coordinates.
˽ Description – A description of the sensor’s location.
˽ Use Location/Description From Device – Attempt to find appropriate strings on de-
vice config fields. As with the SmartSensor AutoDetect, this will overwrite any manual
changes to location/description if checked.
˽ Baud Rate – Baud rate for modem connection (Diamond devices are modem com-